Krieghoff K-80 Stock Bolt & Weight Balance System
640**
$99.00 – $375.00
K-80 Stock Weight System – Bolt & Weight(s) The stock screw system is installed in the stock bolt access hole under the recoil pad. Installation is simple and involves only removing the original stock bolt and replacing it with the new longer stock bolt. You will reuse the steel washer, spring washers and rubber O ring from your original stock bolt. The bolt itself and the aluminum cup is left over after the exchange. Please Note: Some stocks may have been shortened along with the stock bolt. To ensure you don’t fit the new bolt and risk damaging your gun, please check the length of your existing bolt. You should not be exceeding 8 turns of the stock bolt when fitting. The length of the longer stock bolt is 11 1/2inches. Length of stock bolt from thread to mid piece is 6.6inches. This replacement bolt is designed to fit in place of existing stock bolts of 6.6inch in length. The washers provide a slight amount of spring tension when tightening up the stock bolt. Please note the washer arrangement in the photo. The balance screw carries an adjustable weight that can be positioned anywhere on the top section of the balance screw. The longer stock bolt itself weights an additional 1.4oz in weight to the standard bolt and each weight adds just over 1 ounce. A possible 5 weights can be added to the longer stock bolt, totaling 5.3ounces. This added to the additional 1.4oz of the stock bolt means you can add up to 6.7 oz to the rear end of the gun. Also available for the K-80 Balance System are the K-80 Barrel Weights, combining both systems provides maximum flexibility in handling configuration. We offer a set with the extended stockbolt and three weights, plus extra individual weights.



